June 3, 2015Aerial Work PlatformBarb Fullman Welcome to your Aerial Work Platform Practice Test. Take the test and find out how well prepared you are!1) An aerial work platform operator's permit must be renewed every Year 2 Years 3 years None of the above2) The minimum safe operating distance from energized power lines operating at less than 50 kv. and more than 300 volts is: 2 feet 6 feet 10 feet None of the above3) Hydrolic controls shall do or have which of the following: return to neutral when released to be protected against inadvertent operation be clearly marked as to intended function All of the above4) Ground controls or manual descent may only be used to help position the platform in an emergency for a functional check prior to the operation Both b and c are correct5) Where can the maximum platform capacity rating always be found on the boom lift? on the unit's serial number plate on the chassis in the operation and safety handbook at the ground control station6) When using a safety harness on a boom lift, the tether lanyard is attached from the designated location in the basket: at the center of your back in the ring provided at your side does not matter at your front7) The auxiliary power system of a boom lift should be used to make it go faster only if the batteries are dead only in an emergency only if there is more than 1 person aboard8) Any object can be lifted with an aerial work platform as long as the load chart capacity is not exceeded. True False9) How far must you stay away from electrical conductors? 10 feet 20 feet 50 feet it varies with the voltage range phase to phase10) It is okay to make modifications to a work platform when doing special jobs as long as the changes are reversed when done with the job. True False11) Which of the following is required by OSHA? Any AWP operator must be trained and tested by a qualified person before operating an AWP on their own. Any AWP operator must read the manufacturer’s manual before being allowed to operate the AWP. All operators must wear a hard hat. All of the above. 12) In an emergency, what control set will override the platform? Ground controls Tilt alarm Foot switch Taking the start key out of the machine will reset it and fix any problem. Please let us know you're not a robot by typing in the digits below!Please fill out your contact information so you can get your results sent to your email! Name Business Email Phone Number Read More About Barb Barbara Fullman, CEO of Total Equipment Training.